Bending stainless steel sheet radius fracture


Center for Precision Forming (www.cpforming.org Taylan Altan, Director (e-mail: [email protected]) A short Review March 2014 1 ME477 Fall 2004 Kwon 1 1 SHEET METALWORKING 1. Cutting Operation 2. Bending Operation 3. Drawing 4. Other Sheet-metal Forming 5. Dies and Presses 6. Sheet-metal Operation 7. Bending of Tube Stock 2 Introduction • Cutting and forming thin sheets of metal usually performed as cold working • Sheet metal = 0.4 (1/64) to 6 mm (1/4in) thick ... China Radius Plates China, China Radius Plates China Suppliers and Manufacturers Directory - Source a Large Selection of Radius Plates China Products at radius plate ,distal radius plate ,radius and ulna plate from China Alibaba.com ENT145/3 Materials Engineering Tutorial 2 (Answer) 1. A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension with a load of 89,000 N, and experiences an elongation of 0.10 mm. Assuming that the deformation is entirely elastic, calculate the elastic modulus of the steel. 2.